A.feed pump suction line
B.hot well
C.shell of the feed heater
D.feed lines to the boiler
您可能感興趣的試卷
你可能感興趣的試題
A.rise when the steam pressure is increased
B.remain constant as long as the feed pump operates
C.fall when the steam pressure is decreased
D.vary as the steam demand changes
A.to raise water level
B.only while making steam
C.to remove scum
D.when fire are secured
A.drop as the boiler warms up
B.rise as the boiler warms up
C.remain unchanged until the boiler is hot enough
D.rise and fall with the steam demand
A.filled with water
B.purged
C.cleared of air
D.None of the above is true
A.Safety valves
B.Water tubes
C.Steam stop valves
D.Blow down valves
最新試題
Pitting in the suction areas of a centrifugal pump bronze impeller is usually caused by （）.
The temperature differential occurring between the inlet temperature of the fluid to be cooled and the outlet temperature of the cooling medium in a shell-and-tube heat exchanger is greatest in which of the flow designs listed?（）
The general purpose of a heat exchanger is to （）.
A grease gun is generally used to lubricate a （）.
Which of the following problems could cause the high pressure cutout switch to shut down the compressor in a refrigeration system?（）
An excessive charge of refrigerant in an air-cooled refrigeration system can cause （）.
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by （）.
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be （）.
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will （）.
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should （）.