A.high discharge pressure
B.frosting of the crankcase
C.high temperature of the overboard water
D.low suction pressure of compressor
您可能感興趣的試卷
你可能感興趣的試題
A.upper part of the receiver
B.upper part of the condenser
C.down stream end of the cooling coil
D.outlet end of the condenser
A.icing of the automatic controls
B.embrittlement of some parts of the automatic controls
C.sludge in the lubricating oil
D.all of the above
A.low water level
B.high water level
C.excessively high fuel pressure
D.low oil temperature
A.excessive water in the bilges
B.a clogged suction strainer
C.oil in the bilges
D.All of the above
A.in the store room
B.in the cylinder
C.in the scavenge air box
D.in the water box
最新試題
Heavy wear in a particular area of the inner circumference of a packing ring may be caused by ().
The control mode in which the final control element is moved from one of two flexed positions to the other is known as ().
The temperature differential occurring between the inlet temperature of the fluid to be cooled and the outlet temperature of the cooling medium in a shell-and-tube heat exchanger is greatest in which of the flow designs listed?()
Pitting in the suction areas of a centrifugal pump bronze impeller is usually caused by ().
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be ().
The amount of fluid friction or internal friction inherent in a mineral lubricating oil is reflected as a measure of its ().
An excessive charge of refrigerant in an air-cooled refrigeration system can cause ().
The rate of heat transfer from a hot region to a cold region is affected most by the ().
Which of the problems listed would came the discharge temperature of an R-12 refrigeration compressor to increase?()
A salinity indicator is used to determine the ().