A.open
B.close
C.remain in its position
D.flood the evaporator with refrigerant
您可能感興趣的試卷
你可能感興趣的試題
A.low water level
B.low oil pressure
C.excessively high fuel pressure
D.an improper air/fuel ratio
A.Condenser leakage
B.A shortage of liquid refrigerant
C.Excessive frost on the evaporator
D.Not enough condenser cooling water
A.high discharge pressure
B.frosting of the crankcase
C.high temperature of the overboard water
D.low suction pressure of compressor
A.upper part of the receiver
B.upper part of the condenser
C.down stream end of the cooling coil
D.outlet end of the condenser
A.icing of the automatic controls
B.embrittlement of some parts of the automatic controls
C.sludge in the lubricating oil
D.all of the above
最新試題
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by ().
Pitting in the suction areas of a centrifugal pump bronze impeller is usually caused by ().
An excessive charge of refrigerant in an air-cooled refrigeration system can cause ().
If the suction pressure at the refrigeration compressor is below normal, the cause can be().
The major source of chemical contaminants in hydraulic fluid is ().
If the head pressure of a reciprocating refrigeration compressor is excessive, ().
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will ().
Which of the problems listed would came the discharge temperature of an R-12 refrigeration compressor to increase?()
A grease gun is generally used to lubricate a ().
A salinity indicator is used to determine the ().