A.the piston rod
B.the tiller arm
C.the connecting rod
D.the rudder
您可能感興趣的試卷
你可能感興趣的試題
A.fouled tubes in shell and tube condenser
B.too little or too warm condenser water
C.air or non-condensable gas in system
D.overcharge of refrigerant
A.The winch motor
B.The band brake
C.The winch barrel
D.The anchor capstan
A.The cable lifter
B.The hoisting motor
C.The topping wire
D.The life-raft
A.stays
B.winches
C.barrels
D.brakes
A.fire-tubes
B.furnaces
C.water drums
D.water wall tubes
最新試題
A grease gun is generally used to lubricate a ().
The control mode in which the final control element is moved from one of two flexed positions to the other is known as ().
The amount of fluid friction or internal friction inherent in a mineral lubricating oil is reflected as a measure of its ().
The general purpose of a heat exchanger is to ().
On tank vessels equipped with power operated cargo tank valves, the type of power operator most commonly used is ().
Pitting in the suction areas of a centrifugal pump bronze impeller is usually caused by ().
If the thermal bulb of an expansion valve is incorrectly placed at the center of the coil instead of the end, it will ().
Which of the following statements is correct concerning heat transfer?()
The usual symptoms of cavitation in a centrifugal pump is ().
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should ().