A.refrigerant must be bled off the sensing line before adjustments are made
B.all refrigerant must be pumped into the receiver before adjustments are made
C.time must be allowed for conditions to stabilize in the evaporator before further adjustments are made
D.all refrigerant must be routed through the dehydrator while changing the superheat setting
您可能感興趣的試卷
你可能感興趣的試題
A.motor controller overload would open
B.pump would eventually overheat
C.relief valve would continuously cycle open
D.motor would overheat
A.have a greater head capacity
B.operate with increased impeller efficiency
C.discharge through the suction side of the pump casing
D.require more power to run the shaft
A.hydraulic fluid contamination
B.excessive fluid friction
C.turbulent fluid flow
D.fluid pressure surges
A.yearly
B.quarterly
C.monthly
D.daily
A.evaporator pressure decrease
B.evaporator coil over-feed
C.evaporator capacity increase
D.expansion valve diaphragm rupture
最新試題
Low compressor head pressure in a refrigeration system can be caused by（）.
Which of the listed pumps is NOT a positive displacement pump?（）
One cause of high head pressure occurring in a refrigeration system can be （）.
If the suction pressure at the refrigeration compressor is below normal, the cause can be（）.
A gradual decrease in the discharge pressure of an operating hydraulic pump can be caused by （）.
When a refrigeration compressor has developed a high head pressure as a result of a refrigerant overcharge, you should （）.
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be （）.
The rate of heat transfer from a hot region to a cold region is affected most by the （）.
When the steering gear is in operation, you should （）.
An excessive charge of refrigerant in an air-cooled refrigeration system can cause （）.