A.rapidly
B.by gravity
C.through a standard orifice at a specified temperature
D.at a rate of 60cc per second
您可能感興趣的試卷
你可能感興趣的試題
A.flooding back
B.superheating
C.overflowing
D.recycling
A.Absorb erosion of high velocity discharge stream
B.Seal pump shaft against entry of air
C.Isolate the discharge side from the suction side
D.Dampen the turbulent discharge flow
A.cooling only
B.cooling and humidifying
C.cooling and dehumidifying
D.adiabatic cooling
A.Sea water is heated to boiling temperature while under a vacuum
B.Sea water is passed over heated plates in a thin film
C.Heated sea water is injected into a vacuum chamber
D.Sea water is forced through a heated eductor
A.Vapor pockets formed in the suction flow stream
B.Rough easing volute surfaces
C.Worn wearing rings
D.Heavy fluid in the flow stream
最新試題
Heavy wear in a particular area of the inner circumference of a packing ring may be caused by （）.
The usual symptoms of cavitation in a centrifugal pump is （）.
Thermostatic expansion valves can be adjusted for （）.
If the suction pressure at the refrigeration compressor is below normal, the cause can be（）.
A salinity indicator is used to determine the （）.
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be （）.
A pressure drop through the refrigerant liquid line may cause （）.
The general purpose of a heat exchanger is to （）.
If the thermal bulb of an expansion valve is incorrectly placed at the center of the coil instead of the end, it will （）.
The temperature differential occurring between the inlet temperature of the fluid to be cooled and the outlet temperature of the cooling medium in a shell-and-tube heat exchanger is greatest in which of the flow designs listed?（）