A.under heavy loads
B.during hot gas defrost
C.under light loads
D.during starting conditions
您可能感興趣的試卷
你可能感興趣的試題
A.Excessive compression in the cylinder
B.A broken intake valve
C.A dirty inlet filter element
D.An improperly adjusted discharge valve
A.Constant tension mooring winch system
B.Hatch cover system
C.Watertight door system
D.Internal combustion engine hydraulic starter system
A.Carbon build up in the piston ring belt
B.Faulty operation of a cylinder un-loader
C.Compressor operation in an area of high relative humidity
D.Lifting of intercooler rebel valve
A.system was overcharged with refrigerant
B.system was low on refrigerant
C.suction valves were leaking slightly
D.relief valve was leaking slightly
A.broken inlet valves
B.broken discharge valves
C.pulsations in the air distribution system
D.overloading of the air distribution system
最新試題
When the steering gear is in operation, you should （）.
Which of the problems listed would came the discharge temperature of an R-12 refrigeration compressor to increase?（）
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will （）.
The output volume of a positive fixed displacement pump can be changed only by （）.
A salinity indicator is used to determine the （）.
If the head pressure of a reciprocating refrigeration compressor is excessive, （）.
Pitting in the suction areas of a centrifugal pump bronze impeller is usually caused by （）.
The usual symptoms of cavitation in a centrifugal pump is （）.
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should （）.
If the viscosity of the liquid being transferred remains constant as the discharge pressure increases, the rotary pump （）.