A.The hose should not be twisted
B.The hose should be protected with a sleeve if it is subjected to rubbing
C.There should be some slack in the hose
D.All of the above
您可能感興趣的試卷
你可能感興趣的試題
A.acid
B.fuel oil
C.sediment
D.water
A.Main circulator pump jacket water cooling
B.Salt water service pump
C.Auxiliary condensate pump
D.Bilge pump
A.cause a loss of the liquid seal
B.create a vapor lock in the liquid receiver
C.collect in the condenser
D.cause foaming of the oil in the crankcase
A.only by the pump as its primary function
B.by resistance to the fluid flow through the system
C.by the thermal input to the systems fluid
D.solely by the charge applied by the accumulators
A.increase the flow of the cooling water through the condenser
B.adjust the high pressure cutout to maintain the desired pressure
C.open the hot gas bypass temporarily to reduce capacity
D.purge non-condensable gases to reduce the excess pressure
最新試題
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should （）.
When a refrigeration compressor has developed a high head pressure as a result of a refrigerant overcharge, you should （）.
A grease gun is generally used to lubricate a （）.
If the suction pressure at the refrigeration compressor is below normal, the cause can be（）.
The control mode in which the final control element is moved from one of two flexed positions to the other is known as （）.
The output volume of a positive fixed displacement pump can be changed only by （）.
Pitting in the suction areas of a centrifugal pump bronze impeller is usually caused by （）.
The rate of heat transfer from a hot region to a cold region is affected most by the （）.
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will （）.
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by （）.