單項選擇題Pitting in the suction areas of a centrifugal pump bronze impeller is usually caused by ().

A.cavitation
B.electrolysis
C.abrasion
D.corrosion


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題If the head pressure of a reciprocating refrigeration compressor is excessive, ().

A.the relief valve should open before the high pressure cutout
B.the relief valve should open and allow the excess refrigerant to flow to the receiver
C.the high pressure cutout switch should operate before the relief valve opens
D.you should close in on the suction valve

2.單項選擇題A salinity indicator is used to determine the ().

A.cause of salt contamination
B.location of salt water contamination
C.chemical makeup of feed-water
D.level of alkalinity in condensate

3.單項選擇題An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by ().

A.restriction in refrigerant piping
B.air and non-condensable gases in the condenser
C.water in the refrigerant
D.flooding back of liquid refrigerant from the evaporator

4.單項選擇題Which of the following problems could cause the high pressure cutout switch to shut down the compressor in a refrigeration system?()

A.A shortage of liquid refrigerant
B.Excessive frost on the evaporator
C.Excessive condenser cooling water
D.Insufficient condenser cooling water flow

5.單項選擇題The general purpose of a heat exchanger is to ().

A.eliminate hot air from the condenser
B.maintain steady pressure in a system
C.heat, or cool one fluid by means of another fluid
D.reduce the engine room temperature in tropical climates