A.for atomizing
B.for centrifuging
C.in a storage tank
D.in the re-circulating line
您可能感興趣的試卷
你可能感興趣的試題
A.expansion space to leave in a tank
B.flash point at which the fuel will burn
C.temperature to which the fuel must be heated
D.rate at which the fuel can be pumped during transfer operations
A.Fire point
B.Flash point
C.Specific gravity
D.viscosity
A.severe electrical storm
B.fire on the pier
C.fire on the ship
D.any of the above
A.1% to 3%
B.1% to 2%
C.4%
D.2% to 4%
A.bunker at a normal rate
B.check for kinks in hose
C.close valves slowly
D.shut valves before topping off
最新試題
Flame failure in an automatically fired auxiliary boiler can from a/an （）
The ISPS Code consists of a mandatory section-Part A, which shows（）
The condensers located in various stages of a flash evaporator are cooled by（）
Engine parameters shall be corresponded to NOx Technical Files. This is required by （）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
The main purpose of port State control is not to（）
Under MARPOL Code the ship to which it applies has to carry （）
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to （）
The shipboard oil pollution emergency plan will be invalid after （）