A.have a larger than normal dead band
B.produce excessive speed response to a load change
C.respond slowly to any change in engine load
D.stabilize engine speed at the new governor setting
您可能感興趣的試卷
你可能感興趣的試題
A.plating forming the engine room tank top
B.doubler plating installed over the flat keel plate
C.a watertight boundary formed by the inner bottom
D.compartments between the inner and outer bottoms
A.auto-ignition point
B.flash point
C.burning temperature
D.fire point
A.double bottom fuel oil tank temperature
B.heater supply steam flow
C.pressure of the fuel supplied to the burners
D.attemperator steam flow in the heater discharge circuit
A.have no plating joints of 90
B.retain the lube oil as long as possible before it recirculates through the system
C.provided drain/return lines that are no greater than 24 inches from the pump suction
D.be provided with only a perfectly horizontal bottom
A.cause an alarm condition
B.secure power to the indicator
C.secure power to the monitored device
D.automatically recluse within 10 seconds
最新試題
During the diesel engine running, the water level of F.W expansion tank should normally kept in the () level of glass tube.
Which one is NOT the ‘clear grounds’ for a more detailed inspection?()
The treatment of the fuel oils involves storage, heating, filtering and()
Using a file without a handle may result in ()
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to ()
When does auxiliary burner of incinerator put into operation? ()Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated()
The ISPS Code consists of a mandatory section-Part A, which shows()
Which of the diesel engine components listed increase air density and helps to improve engine operating efficiency?()
The condensers located in various stages of a flash evaporator are cooled by()