A.decrease in ignition lag
B.increase in fuel economy
C.reduction in lube oil viscosity
D.increase in cylinder misfiring
您可能感興趣的試卷
你可能感興趣的試題
A.No fuel will be delivered
B.The maximum effective stroke will be attained
C.The fuel delivered to the cylinder will be excessive
D.The injection nozzle will overheat and carbonize
A.have a larger than normal dead band
B.produce excessive speed response to a load change
C.respond slowly to any change in engine load
D.stabilize engine speed at the new governor setting
A.plating forming the engine room tank top
B.doubler plating installed over the flat keel plate
C.a watertight boundary formed by the inner bottom
D.compartments between the inner and outer bottoms
A.auto-ignition point
B.flash point
C.burning temperature
D.fire point
A.double bottom fuel oil tank temperature
B.heater supply steam flow
C.pressure of the fuel supplied to the burners
D.attemperator steam flow in the heater discharge circuit
最新試題
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the()
If two A.C.generators are to be operated in parallel, the load is distributed evenly by()
When does auxiliary burner of incinerator put into operation? ()Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
For a given exhaust gas boiler, what is the quantity of its evaporation mainly determined?()
The shipboard oil pollution emergency plan will be invalid after ()
Engine parameters shall be corresponded to NOx Technical Files. This is required by ()
Flame failure in an automatically fired auxiliary boiler can from a/an ()
The Port State Control officer may witness a fire drill carried out by the crew assigned to these duties on the()
Which one is NOT the ‘clear grounds’ for a more detailed inspection?()
To shut down a diesel engine after it exceeds the set maximum speed,which type of device listed should be used?()