A.power and intake
B.intake and exhaust
C.exhaust and compression
D.compression and power
您可能感興趣的試卷
你可能感興趣的試題
A.Hydraulic oil pressure
B.Servomotor action
C.Flyweight centrifugal force
D.Relay motion
A.low coolant temperature
B.insufficient fuel
C.high ambient temperature
D.carbon buildup on the injector tips
A.the splashing of lubrication oil by the crankshaft
B.the dilution of crankcase oil with particles of combustion
C.broken fuel lines spraying oil on the crankcase
D.the ignition of unburned fuel and air in the crankcase
A.Lube oil pressure and temperature
B.jacket water pressure and temperature
C.Engine over-speed
D.Lube oil sump level
A.To add power to the engine
B.To keep the engine firmly attached to its supporting base
C.To keep moving engine part in their proper relative positions
D.To rotate the crankshaft
最新試題
The ISPS Code consists of a mandatory section-Part A, which shows（）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
If two A.C.generators are to be operated in parallel, the load is distributed evenly by（）
The condensers located in various stages of a flash evaporator are cooled by（）
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated（）
Engine parameters shall be corresponded to NOx Technical Files. This is required by （）
Which one is NOT the ‘clear grounds’ for a more detailed inspection?（）
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is（）
If separating effect is not good, which measure should be taken （）
The main purpose of port State control is not to（）