A.injection lag
B.ignition delay
C.compression
D.turbulence lag
您可能感興趣的試卷
你可能感興趣的試題
A.a spark plug
B.injectors
C.the heat of compression
D.increasing jacket water temperatures
A.one automatic drain serving both containers
B.two air starting containers of approximately equal size
C.one control air container and one starting air container
D.one additional means of starting the main engine
A.prevent heat corrosion to internal components
B.increase fuel delivery rate and economy
C.prevent pre-ignition
D.avoid carbonization of the nozzle tips
A.loss of suction in the circulating pump
B.leak in the primary cooling system
C.broken raw water pump shaft
D.burned or cracked piston in one cylinder
A.avoid using liquid-cooled nozzles whenever possible
B.avoid low cooling water temperatures
C.avoid prolonged overloading of the engine
D.make certain the gasket seal between the nozzle and cylinder head is tight
最新試題
If separating effect is not good, which measure should be taken ()
Which of the diesel engine components listed increase air density and helps to improve engine operating efficiency?()
The shipboard oil pollution emergency plan will be invalid after ()
“Insufficiency of manning or insufficiency of certification of seafarers” is an identification of a()
To proceed to the assistance of a ship in distress is()
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?()
If two A.C.generators are to be operated in parallel, the load is distributed evenly by()
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the()
Diesel engine air start system check valves are opened by ()
The condensers located in various stages of a flash evaporator are cooled by()