A.sea water temperature must never be warmer than 40℃
B.jacket water pressure should always be greater than the sea water pressure
C.jacket water temperature must always be less than 60℃
D.jacket water pressure must always be less than the sea water pressure
您可能感興趣的試卷
你可能感興趣的試題
In a medium speed diesel engine, a trunk type piston may be cooled by（）
Ⅰ.oil circulation though passages in the piston crown
Ⅱ.heat transfer through piston rings and liner wall
A.Ⅰ only
B.Ⅱ only
C.either Ⅰ or Ⅱ
D.neither Ⅰ or Ⅱ
A.power the after-coolers
B.power the turbocharger
C.reduce the cylinder scavenge effect
D.cool the turbocharger
A.corrosive deterioration of a bearing
B.inadequate air filtration
C.excessive ring and liner wear
D.excessive cooling of lubricating oil
A.lower than normal cylinder pressure and low exhaust temperature
B.lower than normal cylinder pressure and high exhaust temperature
C.higher than normal cylinder pressure and low exhaust temperature
D.higher than normal cylinder pressure and high exhaust temperature
A.engine displacement
B.super-aspirating
C.air injection
D.supercharging
最新試題
（）connectors hold best if a wire is accidentally pulled or a connection becomes loose.
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is（）
Which of the diesel engine components listed increase air density and helps to improve engine operating efficiency?（）
The main purpose of port State control is not to（）
Flame failure in an automatically fired auxiliary boiler can from a/an （）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
The treatment of the fuel oils involves storage, heating, filtering and（）
Using a file without a handle may result in （）
The shipboard oil pollution emergency plan will be invalid after （）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish