A.clogged fuel injection pumps
B.increased cylinder liner wear
C.intake valve stem corrosion
D.varnish deposit on pistons
您可能感興趣的試卷
你可能感興趣的試題
A.Injection lag
B.Lube oil dilution
C.Pre-ignition
D.Corrosion
A.increase thermal efficiency
B.cause clogging of the fuel system
C.increase the ability of the engine to start in cold weather
D.produce corrosion in the cylinder and exhaust system at low loads
A.the engine to run after the fuel has been secured
B.the engine to over-speed
C.a fire
D.all of the above
A.compression pressure in the cylinder will be higher
B.carbon will accumulate behind the ring
C.combustion gases will penetrate beneath the ring land
D.piston side thrust will be increased
A.copper
B.carbon
C.hydrogen
D.sulfur
最新試題
() is not installed on the main switchboar.
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is()
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated()
To shut down a diesel engine after it exceeds the set maximum speed,which type of device listed should be used?()
Cold weather starting of a diesel engine may be made easier by()
The treatment of the fuel oils involves storage, heating, filtering and()
Diesel engine air start system check valves are opened by ()
()connectors hold best if a wire is accidentally pulled or a connection becomes loose.
If two A.C.generators are to be operated in parallel, the load is distributed evenly by()
Under MARPOL Code the ship to which it applies has to carry ()