A.Viscosity
B.Sulfur content
C.Pour point
D.Cetane number
您可能感興趣的試卷
你可能感興趣的試題
A.Exhaust energy would draw excess air
B.The inertia of the turbocharger rotor causes a time lag which delays the turbocharger speed increase
C.Exhaust gas pumping losses are increased due to turbine windage
D.Exhaust gas back pressure falls slightly due to increased nozzle action
A.use of low viscosity oil in cold weather
B.increased moisture content of inlet air in cold weather
C.increased drag of pistons and bearings due to increased oil viscosity
D.higher compression pressures reached due to smaller clearances existing in the engine during cold weather
A.octane number
B.cetane number
C.viscosity in Saybolt seconds
D.air fuel ratio
A.Decreasing scavenge air pressure
B.Increasing exhaust temperatures before the turbine
C.Reduction in engine speed
D.All of the above
A.quality of air filtration
B.effectiveness of lubrication
C.type of fuel used
D.all of the above
最新試題
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the()
“Insufficiency of manning or insufficiency of certification of seafarers” is an identification of a()
For a given exhaust gas boiler, what is the quantity of its evaporation mainly determined?()
The ISPS Code consists of a mandatory section-Part A, which shows()
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a()
() is not installed on the main switchboar.
Engine parameters shall be corresponded to NOx Technical Files. This is required by ()
The cetane rating of diesel fuel is an indication of the ()
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is()
The shipboard oil pollution emergency plan will be invalid after ()