A.Liner wear is distributed equally between the upper and lower portions of the cylinder
B.Excessive liner wear causes wear between piston ring and groove
C.Excessive, but uniform liner wear will not cause wear between piston ring and groove
D.Liner wear is normally greatest in the middle of the cylinder
您可能感興趣的試卷
你可能感興趣的試題
A.alternation of side thrust
B.a breakdown of the lube oil film on the cylinder wall
C.worn piston boss piston pin bearings
D.fluctuating gas pressure in the combustion space
A.hard starting
B.excessive fuel consumption
C.loss of power
D.all of the above
A.provide added wear protection against today’s corrosive quality of fuel
B.increase overall valve strength due to the high gas pressures
C.assist in dissipating heat due to the extreme operating temperatures
D.reduce the overall weight of the valve thus helping eliminate valve spring surge and hammering
A.Excessive piston to liner clearance
B.The underside of the piston crown being excessively dirty lowering the rate of heat transfer
C.Faulty nozzle spray
D.All of the above
A.improve skirt lubrication
B.allow for expansion
C.transmit forces evenly
D.improve the piston seal
最新試題
Engine parameters shall be corresponded to NOx Technical Files. This is required by ()
Flame failure in an automatically fired auxiliary boiler can from a/an ()
If separating effect is not good, which measure should be taken ()
If two A.C.generators are to be operated in parallel, the load is distributed evenly by()
The main purpose of port State control is not to()
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated()
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a()
() is not installed on the main switchboar.
Cold weather starting of a diesel engine may be made easier by()
Which of the following items don’t belong to dock repair works?()