A.starting the engine hot
B.knurling the piston skirt
C.operating an overheated engine
D.using scuff resistant piston rings
您可能感興趣的試卷
你可能感興趣的試題
A.the amount of lube oil additives increase
B.piston speeds increase
C.injection pressure decrease
D.engine speeds decrease
A.less piston slap and quieter running
B.increased crankshaft bearing wear
C.slightly greater piston wear
D.decreased side pressures
A.Liner wear is distributed equally between the upper and lower portions of the cylinder
B.Excessive liner wear causes wear between piston ring and groove
C.Excessive, but uniform liner wear will not cause wear between piston ring and groove
D.Liner wear is normally greatest in the middle of the cylinder
A.alternation of side thrust
B.a breakdown of the lube oil film on the cylinder wall
C.worn piston boss piston pin bearings
D.fluctuating gas pressure in the combustion space
A.hard starting
B.excessive fuel consumption
C.loss of power
D.all of the above
最新試題
Which of the following items don’t belong to dock repair works?()
Diesel engine air start system check valves are opened by ()
The main purpose of port State control is not to()
The cetane rating of diesel fuel is an indication of the ()
The additional mark ()in the Classification Certificate for Machinery means propulsion apparatus is remotely controlled on the navigating bridge control station, and engine assembly control station is unmanned periodically.
Which one is NOT the ‘clear grounds’ for a more detailed inspection?()
The ISPS Code consists of a mandatory section-Part A, which shows()
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the()
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to ()
If separating effect is not good, which measure should be taken ()