A.detecting faulty combustion in individual cylinders
B.adjusting fuel racks to maintain equal loading between cylinders
C.adjusting the load limit setting of the governor at idle conditions
D.calculating engine horsepower
您可能感興趣的試卷
你可能感興趣的試題
A.tension load twice each crankshaft revolution
B.compression load during power and compression strokes
C.inertia load once every four crankshaft revolutions
D.bending loads at bottom and top dead center
A.cooling water leaving each cylinder
B.fuel oil entering the injector
C.exhaust gases at various locations
D.lube oil at the bearing supplies
A.low water in the expansion tank
B.improperly seated valves
C.low fuel oil pressure
D.worn or broken cylinder liner sealing rings
A.exhaust
B.fuel oil
C.cooling water
D.cylinder liner
A.improperly seating intake valves
B.leaking cylinder liner seal rings
C.late fuel injection timing
D.carbon deposits on the piston
最新試題
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a()
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is()
Flame failure in an automatically fired auxiliary boiler can from a/an ()
The treatment of the fuel oils involves storage, heating, filtering and()
() is not installed on the main switchboar.
If separating effect is not good, which measure should be taken ()
If two A.C.generators are to be operated in parallel, the load is distributed evenly by()
Using a file without a handle may result in ()
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the()
To shut down a diesel engine after it exceeds the set maximum speed,which type of device listed should be used?()