A.when the boiler has been secured long enough for most solids to settle
B.when the boiler has been cooled to ambient temperature
C.only after raising the water level to within 0~5 inch of the high water cutout only
D.after bypassing the low pressure
您可能感興趣的試卷
你可能感興趣的試題
A.completely drain the boiler in an emergency
B.prevent sludge from forming in the drum
C.remove floating impurities from the boiler water surface
D.remove settled solids from the water drum
A.defective solenoid valve
B.dirty fuel nozzle
C.grounded high tension lead
D.faulty ignition cable connector
A.excessive purging before lighting off
B.insufficient trail for ignition period
C.a faulty transformer in the ignition circuit
D.insufficient purging before lighting off
A.prevent engine back pressure at heavy loads
B.increase total engine efficiency at low loads
C.prevent boiler corrosion at low engine loads
D.improve engine fuel consumption at any load
A.steam demand is high
B.salinity is high
C.safety valve simmers
D.burner flame is extinguished
最新試題
The main purpose of port State control is not to()
Which one is NOT the ‘clear grounds’ for a more detailed inspection?()
When does auxiliary burner of incinerator put into operation? ()Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
If separating effect is not good, which measure should be taken ()
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated()
The shipboard oil pollution emergency plan will be invalid after ()
Under MARPOL Code the ship to which it applies has to carry ()
The condensers located in various stages of a flash evaporator are cooled by()
Flame failure in an automatically fired auxiliary boiler can from a/an ()
Engine parameters shall be corresponded to NOx Technical Files. This is required by ()