A.100PPM oily water separator
B.Assembling the lube oil purifier as a separator and aligning bilge overboard
C.A 15PPM oily water separator
D.A magnetic duplex strainer
您可能感興趣的試卷
你可能感興趣的試題
A.insufficient speed
B.cavitation
C.excess discharge pressure
D.excessive net positive suction head B
A.gate valve
B.globe valve
C.swing-check valve
D.plug-cock valve
A.diameter of the discharge piping, with all other factors remaining the same
B.diameter of the suction piping, with all other factors remaining the same
C.width of the impeller only
D.diameter of the impeller
A.Oil is discharged from the impeller through the outlet
B.Gravity causes the oil to flow toward the discharge
C.The self-priming feature of the centrifugal pump enables it to draw its own suction as it starts
D.The discharge capacity varies directly with the speed of the impeller
A.distance of the suction liquid level above the line of the pump
B.distance the suction liquid level is below the center line of the pump
C.force necessary to overcome frictional losses in the pump and piping
D.amount in inches of mercury the total suction head is below atmospheric pressure
最新試題
The shipboard oil pollution emergency plan will be invalid after ()
“Insufficiency of manning or insufficiency of certification of seafarers” is an identification of a()
During the diesel engine running, the water level of F.W expansion tank should normally kept in the () level of glass tube.
To proceed to the assistance of a ship in distress is()
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?()
If separating effect is not good, which measure should be taken ()
The Port State Control officer may witness a fire drill carried out by the crew assigned to these duties on the()
Engine parameters shall be corresponded to NOx Technical Files. This is required by ()
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated()
When does auxiliary burner of incinerator put into operation? ()Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish