A.Carbon particles
B.Lube oil
C.Gasoline
D.Diesel fuel
您可能感興趣的試卷
你可能感興趣的試題
A.Contamination of the lube oil by emulsification will result
B.The lube oil will not be subjected to the proper centrifugal force
C.The lube oil will overheat and flash
D.Oil will discharge from the heavy phase discharge port and be wasted
A.rated capacity of that purifier
B.viscosity of the oil being purified
C.maximum design speed of that purifier
D.specific gravity of the oil being purified
A.the purifier driving gears are lubricated by the reclaimed
B.oil as it leaves the bowl all dirt and sludge are automatically discharged with the cooling water
C.sealing water must never be supplied until after oil is fed to the unit
D.deterioration of the bowl ring gasket will cause the purifier to lose its water seal
A.breaking up solid matter into fine particles
B.precipitating non-decomposed waste in a collection tank
C.chemically adjusting the sewage ph to 7-0
D.eliminating bacterium coli from the sewage
A.100PPM oily water separator
B.Assembling the lube oil purifier as a separator and aligning bilge overboard
C.A 15PPM oily water separator
D.A magnetic duplex strainer
最新試題
The Port State Control officer may witness a fire drill carried out by the crew assigned to these duties on the（）
Diesel engine air start system check valves are opened by （）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
Which of the following items don’t belong to dock repair works?（）
Engine parameters shall be corresponded to NOx Technical Files. This is required by （）
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?（）
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated（）
The treatment of the fuel oils involves storage, heating, filtering and（）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）