A.insufficient refrigeration
B.leaky suction valves
C.expansion valve stuck open
D.suction valve not adjusted properly
您可能感興趣的試卷
你可能感興趣的試題
A.too much cooling water going through the condenser
B.not enough refrigerant in the system
C.a leak in the evaporator coils
D.no enough cooling water going through the condenser
A.king valve and the expansion valve
B.solenoid valve and expansion valve
C.evaporator and receiver
D.compressor and evaporator
A.discharge side of condenser
B.discharge side of compressor
C.outlet of the evaporator
D.receiver tank
A.increase the amount of cooling water to the condenser
B.decrease the amount of cooling water to the condenser
C.add more refrigerant to the system
D.remove some of the refrigerant from the system
A.the relief valve should open before the high-pressure cutout
B.the relief valve should open and let excess refrigerant go to receiver
C.the high-pressure cutout switch should operate before the relief valve opens
D.close in on the suction valve
最新試題
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?（）
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated（）
（） is not installed on the main switchboar.
Flame failure in an automatically fired auxiliary boiler can from a/an （）
Engine parameters shall be corresponded to NOx Technical Files. This is required by （）
Which of the listed governor characteristics will greatly affect the load sharing relationship between paralleled diesel generators?（）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
Which one is NOT the ‘clear grounds’ for a more detailed inspection?（）
The shipboard oil pollution emergency plan will be invalid after （）
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）