A.more economic
B.larger capacity on oil treatment
C.less costive
D.more capable of separating emulsified oil
您可能感興趣的試卷
你可能感興趣的試題
A.gravity separation
B.centrifuge
C.Cyclone
D.Cross-flow membrane filtration
A.The requirement for the oil content of bilge water discharged is 15 ppm
B.No discharge in sensitive waters
C.Any discharge in sensitive waters
D.International, national or local requirements have to be observed
A.The high temperature facilitates primary gravity separation
B.Most of the oil and organic solvents are raised to the top layer
C.The high the temperature is, the more the top oil will be collected
D.The high temperature has little use on the separation of emulsified oil
A.Oil leaking from tanks inside engine room
B.Engine room cleaning water
C.Water leaking from the separator sludge tank
D.Sewage
A.reclaims water
B.purges air without losing refrigerant
C.purges air with some loss of refrigerant
D.purges lube oil from the refrigerant
最新試題
To proceed to the assistance of a ship in distress is()
()connectors hold best if a wire is accidentally pulled or a connection becomes loose.
The cetane rating of diesel fuel is an indication of the ()
The ISPS Code consists of a mandatory section-Part A, which shows()
During the diesel engine running, the water level of F.W expansion tank should normally kept in the () level of glass tube.
“Insufficiency of manning or insufficiency of certification of seafarers” is an identification of a()
Which of the diesel engine components listed increase air density and helps to improve engine operating efficiency?()
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is()
When does auxiliary burner of incinerator put into operation? ()Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
The condensers located in various stages of a flash evaporator are cooled by()