A.It is supplied by the CSU/DSU.
B.It is supplied by the far end router.
C.It is determined by the clock rate command.
D.It is supplied by the Layer 1 bit stream timing.

A.The Router1 WAN port is configured as a trunking port.
B.The Router1 port connected to Switch1 is configured using subinterfaces.
C.The Router1 port connected to Switch1 is configured as 10 Mbps.
D.The Switch1 port connected to Router1 is configured as a trunking port.
E.The Switch1 port connected to Host B is configured as an access port.
F.The Switch1 port connected to Hub1 is configured as full duplex.

A.The subnet mask in use is 255.255.255.192.
B.The subnet mask in use is 255.255.255.128.
C.The IP address 172.16.1.25 can be assigned to hosts in VLAN1
D.The IP address 172.16.1.205 can be assigned to hosts in VLAN1
E.The LAN interface of the router is configured with one IP address.
F.The LAN interface of the router is configured with multiple IP addresses.

A.WAN switch
B.PVC
C.ATM switch
D.multiplexer
E.CSU/DSU
F.modem

A.A successor route is used by EIGRP to forward traffic to a destination.
B.Successor routes are saved in the topology table to be used if the primary route fails.
C.Successor routes are flagged as "active" in the routing table.
D.A successor route may be backed up by a feasible successor route.
E.Successor routes are stored in the neighbor table following the discovery process.