多項(xiàng)選擇題A single 802.11g access point has been configured and installed in the center of a square office. A few wireless users are experiencing slow performance and drops while most users are operating at peak efficiency. What are three likely causes of this problem? (Choose three.) ()

A.mismatched TKIP encryption  
B.null SSID  
C.cordless phones 
D.mismatched SSID  
E.metal file cabinets
F.antenna type or direction 


您可能感興趣的試卷

你可能感興趣的試題

1.多項(xiàng)選擇題What are two reasons that a network administrator would use access lists? (Choose two.) ()。

A.to control vty access into a router  
B.to control broadcast traffic through a router  
C.to filter traffic as it passes through a router  
D.to filter traffic that originates from the router  
E.to replace passwords as a line of defense against security incursions 

2.單項(xiàng)選擇題A default Frame Relay WAN is classified as what type of physical network?()

A.point-to-point  
B.broadcast multi-access  
C.nonbroadcast multi-access  
D.nonbroadcast multipoint 
E.broadcast point-to-multipoint 

最新試題

Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?()

題型:?jiǎn)雾?xiàng)選擇題

Which pairing reflects a correct protocol-and-metric relationship?()

題型:?jiǎn)雾?xiàng)選擇題

After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?()

題型:?jiǎn)雾?xiàng)選擇題

If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?()

題型:?jiǎn)雾?xiàng)選擇題

A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0

題型:?jiǎn)雾?xiàng)選擇題

What is the default administrative distance of OSPF?()

題型:?jiǎn)雾?xiàng)選擇題

Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?()

題型:?jiǎn)雾?xiàng)選擇題

Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?()

題型:?jiǎn)雾?xiàng)選擇題

You have been asked to come up with a subnet mask that will allow all three web servers to be on the same network while providing the max number of subnets.Which network address and subnet mask meet this requirement?()

題型:?jiǎn)雾?xiàng)選擇題

Which address is the IPV6 all-RIP-routers muticast group address that is used by RIPng as the destaion address?()

題型:?jiǎn)雾?xiàng)選擇題