A.255.255.255.0
B.255.255.255.240
C.255.255.255.248
D.255.255.255.252
E.255.255.255.254
您可能感興趣的試卷
你可能感興趣的試題
A.RIP
B.BGP
C.OSPF
D.EIGRP
A.hub
B.router
C.switch
D.STP
E.subinterfaces
F.VLAN
A.This is a 10 Mb/s switch port.
B.This is a 100 Mb/s switch port.
C.This is an Ethernet port operating at half duplex.
D.This is an Ethernet port operating at full duplex.
E.This is a port on a network interface card in a PC
A.IR
B.DSSS
C.FHSS
D.DSSS and FHSS
E.IR, FHSS, and DSSS
A.ATM
B.IDS
C.IOS
D.IOX
E.IPS
F.SDM
最新試題
How are VTP advertisements delivered to switches across the network?()
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
You have been asked to come up with a subnet mask that will allow all three web servers to be on the same network while providing the max number of subnets.Which network address and subnet mask meet this requirement?()
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?()
Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?()
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()
At which layer of the OSI model dose PPP perform?()
When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?()
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?()
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?()