多項選擇題Which of the following are key characteristics of PPP? (Choose three.)()

A.can be used over analog circuits
B.maps Layer 2 to Layer 3 address
C.encapsulates several routed protocols
D.supports IP only
E.provides error correction


您可能感興趣的試卷

你可能感興趣的試題

1.多項選擇題What TCP/IP stack configuration features can DHCP provide, in addition to assigning an IP address? (Choose three.)()

A.default gateway
B.DNS servers
C.FTP server
D.helper address
E.subnet mask
F.TFTP server

2.多項選擇題What are two characteristics of Telnet? (Choose two.)()

A.It sends data in clear text format.
B.It is no longer supported on Cisco network devices.
C.It is more secure than SSH
D.It requires an enterprise license in order to be implemented.
E.It requires that the destination device be configured to support Telnet connections.

3.單項選擇題Which of the following is true regarding the use of switches and hubs for network connectivity?()

A.Switches take less time to process frames than hubs take.
B.Switches do not forward broadcasts.
C.Hubs can filter frames.
D.Using hubs can increase the amount of bandwidth available to hosts.
E.Switches increase the number of collision domains in the network.

4.多項選擇題Which statements are true about EIGRP successor routes? (Choose two.)()

A.A successor route is used by EIGRP to forward traffic to a destination.
B.Successor routes are saved in the topology table to be used if the primary route fails.
C.Successor routes are flagged as "active" in the routing table.
D.A successor route may be backed up by a feasible successor route.
E.Successor routes are stored in the neighbor table following the discovery process.

5.多項選擇題The network security policy requires that only one host be permitted to attach dynamically to each switch interface. If that policy is violated, the interface should shut down. Which two commands must the network administrator configure on the 2950 Catalyst switch to meet this policy? (Choose two.)()

A.Switch1(config-if)# switchport port-security maximum 1
B.Switch1(config)# mac-address-table secure
C.Switch1(config)# access-list 10 permit ip host
D.Switch1(config-if)# switchport port-security violation shutdown
E.Switch1(config-if)# ip access-group 10