單項選擇題Network A has a spanning-tree problem in which the traffic is selecting a longer path. How is the path cost calculated？（）

A.number of hops
B.priority of the bridge
C.interface bandwidth
D.interface delay
E.None of the above


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題

Refer to the exhibit. Which switching feature is being tested?（）

A.loop guard
B.PortFast
C.root guard
D.BDPU guard

2.單項選擇題Customer X has a hub-and-spoke Frame Relay network， with a central office and two branch offices （RemoteA and RemoteB）. Each location has only one physical link to the Frame Relay cloud and RemoteB has a router that is not a Cisco router. Since the installation， there is no connectivity between RemoteB and the central office. What is a possible solution to this issue？（）

A.Because Frame Relay IETF encapsulation is only configurable at interface level， you must use IETF encapsulation on all routers.
B.This is not a possible scenario. A dedicated Frame Relay link to RemoteB is mandatory at the central office.
C.The router at RemoteB must be replaced by a Cisco router.
D.Use Frame Relay IETF encapsulation on a per-VC basis on the central office router.
E.There is a problem in the Frame Relay cloud， because Cisco routers are compatible with IETF Frame Relay.

4.多項選擇題The network administrator wants to enable an EtherChannel between two switches in "on" mode. The administrator connects the cables and enables the interfaces， but while configuring the EtherChannel in the first switch， a spanning-tree loop was detected. Which two of these procedures can avoid this problem？（）

A.Configure the EtherChannel as "desirable" first.
B.Assign all interfaces to the same VLAN.
C.Disable PortFast on the interfaces in the EtherChannels.
D.Disable all interfaces first.
E.Fast Ethernet and Gigabit Ethernet ports cannot be assigned to the same EtherChannel.
F.Fix cabling problems.

最新試題

The following configuration line was added to router R1 Access-list 101 permit ip 10.25.30.00.0.0.255 any What is the effect of this access list configuration?（）

題型：?jiǎn)雾?xiàng)選擇題

A network administrator is troubleshooting the OSPF configuration of routers R1 and R2.The routers cannot establish an adjacency relationship on their common Ethernet link.The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2.Based on the information in the graphic,what is the cause of this problem?（）

題型：?jiǎn)雾?xiàng)選擇題

DHCP SERVER在給一個網段設置POOL時，該網段路由器接口地址能不能放入POOL，能why，不能why。

題型：?jiǎn)柎痤}

What is method list for configure aaa？

題型：?jiǎn)柎痤}

Refer to the exhibit.How many broadcast domains exist in theexhibited topology？（）

題型：?jiǎn)雾?xiàng)選擇題

QoS機制中的分類，采用ip數據包中的哪個字段？

題型：?jiǎn)柎痤}

什么是NAT？

題型：?jiǎn)柎痤}

Refer to the exhibit.The network administrator is in acampus building distant from Building B.WANRouter is hosting a newly installed WAN link on interface S0/0.The new link is not functioning and the administrator needs to determine if the correct cable has been attached to the S0/0 interface.How can the administrator accurately verify the correct cable type on S0/0 in the most efficient manner?（）

題型：?jiǎn)雾?xiàng)選擇題

As a CCNA candidate,you must have a firm understanding of the IPv6 address structure.Refer to IPv6 address,could you tell me how many bits are included in each filed?（）

題型：?jiǎn)雾?xiàng)選擇題

Refer to the exhibit.What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown？（）

題型：?jiǎn)雾?xiàng)選擇題