A. The Ethanalyzer captures control-plane traffic， while SPAN captures all traffic.
B. The Ethanalyzer captures all traffic including control-plane traffic， while SPAN captures only the control-plane traffic.
C. The Ethanalyzer captures only data traffic， while SPAN captures all traffic.
D. The Ethanalyzer captures only control traffic， while SPAN captures data traffic.
您可能感興趣的試卷
你可能感興趣的試題
A. show memory detailed
B. show process cpu sorted
C. show system resources
D. show hardware capacity
A. show interface priority-flow-control
B. show interface queuing
C. show queuing interface
D. show policy-map system type queuing
E. show policy-map interface ethernet
Nexus7000# config t
Nexus700（config）# interface ethernet 2/11
Nexus700（config-if）# switchport mode private-vlan host
Nexus700（config-if）# switchport private-vlan host-association 14 50
Nexus700（config-if）# exit
Nexus700（config）#
What will this command sequence achieve？（）
A. associate interface E2/11 to community VLANs 14 and 50
B. associate interface E2/11 to secondary VLANs 14 and 50
C. associate interface E2/11 to primary VLAN 50 and secondary VLAN 14
D. associate interface E2/11 to primary VLAN 14 and secondary VLAN 50
A. Port priority value can be configured between 1 and 65535.
B. A higher port priority value means a higher priority of LACP.
C. Port priority can be configured so that specific links can be chosen as active links rather than the hot standby links within the port channel.
D. LACP uses the port priority with the port number to form the port identifier.
E. LACP Port priority default value should always be changed
A. Cisco AV-pair
B. TACACS+ or RADIUS ack frame role attribute
C. DH-CHAP challenge attribute
D. privilege level attribute
最新試題
Which two statements about end-host mode in SAN connectivity in a Cisco UCS environment are true？ （）
What would be the cause for the following fault in UCS Manager？（） "ether VIF x / xxx down， reason： ENM source pinning failed"
Given the following output： san-port-channel 12 is up Hardware is Fibre Channel Port WWN is 24：0c：00：0d：ec：d3：5c：00 Admin port mode is NP， trunk mode is on Port mode is NP Port vsan is 1 Speed is 8 Gbps Member[1] ： fc2/3 Member[2] ： fc2/4 What does "Speed is 8 Gbps" indicate？（）
In a Cisco Unified Computing System， where are SAN port channels connected to？（）
Which GSS "source access list" is used to allow access to GSS by clients when GSS is being used as the DNS？（）
A Cisco Application Control Engine Appliance （ACE） non-admin context does not support "sticky" configuration. What is the reason for this issue？（）
Server load balancing （SLB） is the process of deciding to which server a load-balancing device should send a client request for service. Which predictors are supported on ACE in order to select the best server to fulfill a client request？ （）
Application Control Engine （ACE） can check the health of servers and server farms by configuring health probes （which are sometimes referred to as keepalives）. A probe can be one of many types. Which are valid ACE probes？ （）
In a Cisco Unified Computing System， What is the "designated receiver" port in end-host mode used for？（）
Refer to the exhibit. According to the equipment tab in Cisco UCS Manager， which is true？（）