A. Up to 25 m bus length
B. Only one device per SCSI bus
C. Up to 16 devices per SCSI bus
D. Half-duplex operation
E. Full-duplex operation
您可能感興趣的試卷
你可能感興趣的試題
A. Ethernet FCS
B. Source address
C. Destination address
D. EtherType
E. Protocol type
A. It is required to establish the point-to-point FCoE links with the first switch in the path.
B. It is required to establish the point-to-point FCoE links with any switch across multiple Ethernet segments.
C. It is not used to build the FCoE links.
D. It is used to ensure lossless transport.
A. Fibre Channel ports must be configured from the first port in the module.
B. Ethernet ports must be configured from the last port in the module.
C. Fibre Channel ports must be configured from the last port in the module.
D. Ethernet ports must be configured from the first port in the module.
A. LLDP transmit and receive are disabled
B. The initiator server has no connectivity to the target storage
C. FIP negotiation timing
D. Peer does not support LLDP
E. VSAN trunk protocol has been enabled
A. Server’s CNA does not support DCBX and PFC TLV was not negotiated.
B. A "no-drop" class has not been configured for FCoE
C. The system is running with the default QOS policies.
D. The link is oversubscribed.
最新試題
Which three statements are possible causes for the "fltAdaptorHostIfLink-down" fault in UCS Manager？ （）
Which two statements about end-host mode in SAN connectivity in a Cisco UCS environment are true？ （）
On a Cisco Unified Computing System （UCS）， which two statements regarding Ethanalyzer are true？（）
What would be the cause for the following fault in UCS Manager？（） "ether VIF x / xxx down， reason： ENM source pinning failed"
In the event of a GSS failure in a GSS cluster， which is true？（）
Your company wants Server 1/eth0 （vNIC 1） configured so that it always uses Fabric Interconnect A Port Channel 1 （Po1） when it communicates with anything outside of the Cisco UCS domain. However， if vNIC 1 fails over to Fabric Interconnect B using fabric failover， then vNIC 1 can any uplink port on Fabric Interconnect B. Which statements are true？ （）
What is the use of an "all configuration" backup in Cisco UCS？（）
Refer to the exhibit.The Cisco UCS domain is operating in switching mode. A network administrator notices that no traffic is traversing the uplinks on Fabric Interconnect B （Path C）. Which actions might be used to change this behavior？（）
Refer to the exhibit.Your company requires a Cisco UCS configuration that will， at a minimum， allow the configuration in the provided exhibit. Which Cisco UCS components will meet the requirement？（）
An administrator is creating a service profile but receives an error when applying to a blade. The administrator checks the faults tab of the service profile and finds the following error （Refer to the exhibit）.What is the cause of this error？（）