Refer to the exhibit. VTP has been enabled on the trunk links between all switches within the TEST domain. An administrator has recently enabled VTP pruning. Port 1 on Switch 1 and port 2 on Switch 4 are assigned to VLAN 2. A broadcast is sent from the host connected to Switch 1. Where will the broadcast propagate?（）
A.Every switch in the network receives the broadcast and will forward it out all ports.
B.Every switch in the network receives the broadcast，but only Switch 4 will forward it out port 2.
C.Switches 1，2，and 4 will receive the broadcast，but only Switch 4 will forward it out port 2.
D.Only Switch 4 will receive the broadcast and will forward it out port 2.
您可能感興趣的試卷
你可能感興趣的試題
A.30 seconds
B.5 minutes
C.1 minute
D.10 seconds
E.5 seconds
F.None of the other alternatives apply
A.A root VTP server
B.A trunk port
C.VTP priority
D.VLAN 1
E.None of the other alternatives apply
A.STP root status
B.VTP mode
C.Negotiation status
D.Management domain
E.Configuration revision number
A.Devices use DHCP to request their VLAN.
B.Attached devices are unaware of any VLANs.
C.Devices are assigned to VLANs based on their MAC addresses.
D.Devices are in the same VLAN regardless of which port they attach to.
A.VMPS server lookup is required
B.Easy to configure
C.Easy of adds，moves，and changes
D.Based on MAC address of the connected device
最新試題
Refer to the exhibit. What command was issued on the Layer 3 switch Sw1 between Exhibit #1 and Exhibit #2？（）
Examine the diagram. A network administrator has recently installed the above switched network using 3550s and would like to control the selection of the root bridge.Which switch should theadministrator configure as the root bridge and which configuration command must theadministrator enter to accomplish this？（）
Refer to the exhibit and the partial configuration of switch SW_A and SW_B. STP is configured on all switches in the network. SW_B receives this error message on the console port：00：06：34： %CDP-4-DUPLEX_MISMATCH： duplex mismatch discovered on FastEthernet0/5 （not half duplex）， with SW_A FastEthernet0/4 （half duplex） ， with TBA05071417（Cat6K-B） 0/4 （half duplex）. What would be the possible outcome of the problem？（）
Which three statements are true of the Link Aggregation Control Protocol （LACP）？（）
During routine maintenance， it became necessary to shutdown G1/0/1 on DS1 and DS2. All other interface were up. During this time， DS1 became the active device for Vlan104’s HSRP group. As related to Vlan104’s HSRP group. What can be done to make the group function properly ？ （）
Which option correctly identifies the Cisco IOS switching methods in descending order from the fastest method to the slowest method？（）
Which two statements are true when the extended system ID feature is enabled？ （）
What is the configured priority value of the Vlan105’s group on DS2 ？（）
Refer to the exhibit. LACP has been configured on Switch1 as shown. Which is the correct command set to configure LACP on Switch2？（）
If G1/0/1 on DS1 is shutdown， what will be the current priority value of the Vlan105’s group on DS1 ？（）