A.A number for identifying changes to the network switch.
B.A number for identifying changes to the network router.
C.A number for identifying changes to the network topology.
D.None of the other alternatives apply.
您可能感興趣的試卷
你可能感興趣的試題
A.A switch can only reside in one management domain
B.A switch is listening to VTP advertisements from their own domain only
C.A switch is listening to VTP advertisements from multi domains
D.A switch can reside in one or more domains
E.VTP is no longer supported on Catalyst switches
A.VTP messages will not be forwarded over nontrunk links.
B.VTP domain names need to be identical. However，case doesn’t matter.
C.A VTP enabled device which receives multiple advertisements will ignore advertisements with higher configuration revision numbers.
D.A device in "transparent" VTP v.1 mode will not forward VTP messages.
E.VTP pruning allows switches to prune VLANs that do not have any active ports associated with them.
A.Supports Token Ring VLANs.
B.Allows VLAN consistency checks.
C.Saves VLAN configuration memory.
D.Reduces the amount of configuration necessary.
E.Allows active redundant links when used with spanning tree.
A.Enable VTP pruning on any switch in the management domain
B.Enable VTP pruning on any client switch in the domain
C.Enable VTP pruning on a VTP server in the management domain
D.Enable VTP pruning on every switch in the domain
E.None of the other alternatives apply
A.VTP version 2 supports Token Ring VLANs
B.VTP version 2 allows VLAN consistency checks
C.VTP version 2 allows active redundant links when used with spanning tree
D.VTP version 2 reduces the amount of configuration necessary
E.VTP version 2 saves VLAN configuration memory
最新試題
Which two statements are true about BPDU port-guard and BPDU filtering？（）
Examine the diagram. A network administrator has recently installed the above switched network using 3550s and would like to control the selection of the root bridge.Which switch should theadministrator configure as the root bridge and which configuration command must theadministrator enter to accomplish this？（）
Refer to the exhibit. LACP has been configured on Switch1 as shown. Which is the correct command set to configure LACP on Switch2？（）
What will occur when a nonedge switch port that is configured for Rapid Spanning Tree does not receive a BPDU from its neighbor for three consecutive hello time intervals？（）
During routine maintenance， G1/0/1 on DS1 was shutdown. All other interface were up. DS2 became the active HSRP device for Vlan101 as desired. However， after G1/0/1 on DS1 was reactivated. DS1 did not become the active HSRP device as desired. What need to be done to make the group for Vlan101 function properly ？ （）
Refer to the exhibit. The command switchport mode access is issued on interface FastEthernet0/13 on switch CAT1. What will be the result？（）
Refer to the exhibit. Switch S2 contains the default configuration. Switches S1 and S3 both have had the command spanning-tree mode rapid-pvst issued on them. What will be the result？（）
Refer to the exhibit. Switch 15 is configured as the root switch for VLAN 10 but not for VLAN 20. If the STP configuration is correct， what will be true about Switch 15？（）
Refer to the exhibit. Which statement is true about the output？（）
Refer to the exhibit. Initially， LinkA is connected and forwarding traffic. A new LinkB is then attached between SwitchA and HubA. Which two statements are true about the possible result of attaching the second link？（）