Refer to the exhibit. MPLS has been configured on all routers in the domain. In order for R2 and R3 to forward frames between them with label headers, what additional configuration will be required on devices that are attached to the LAN segment?()
A.Decrease the maximum MTU requirements on all router interfaces that are attached to the LAN segment.
B.Increase the maximum MTU requirements on all router interfaces that are attached to the LAN segment.
C.No additional configuration is required. Interface MTU size will be automatically adjusted to accommodate the larger size frames.
D.No additional configuration is required. Frames with larger MTU size will be automatically fragmented and forwarded on all LAN segments.
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. The show mpls interfaces detail command has been used to display information about the interfaces on router R1 that have been configured for label switching. Which statement is true about the MPLS edge router R1?()
A.Packets can be labeled and forwarded out interface Fa0/1 because of the MPLS operational status of the interface.
B.Because LSP tunnel labeling has not been enabled on interface Fa0/1, packets cannot be labeled and forwarded out interface Fa0/1.
C.Packets can be labeled and forwarded out interface Fa1/1 because MPLS has been enabled on this interface.
D.Because the MTU size is increased above the size limit, packets cannot be labeled and forwarded out interface Fa1/1.
A.MPLS eliminates the need of an IGP in the core.
B.MPLS reduces the required number of BGP-enabled devices in the core.
C.Reduces routing table lookup since only the MPLS core routers perform routing table lookups.
D.MPLS eliminates the need for fully meshed connections between BGP enabled devices.
A.reset the connection
B.forward the packet
C.check the packet against an ACL
D.drop the packet
A.A static route that points towards the Cisco Easy VPN server is created on the remote client.
B.A static route is created on the Cisco Easy VPN server for the internal IP address of each VPN client.
C.A default route is injected into the route table of the remote client.
D.A default route is injected into the route table of the Cisco Easy VPN server.
A.Configure SNMP with only read-only community strings.
B.Encrypt TFTP and syslog traffic in an IPSec tunnel.
C.Implement RFC 3704 filtering at the perimeter router when allowing syslog access from devices on the outside of a firewall.
D.Synchronize the NTP master clock with an Internet atomic clock.
E.Use SNMP version 2.
F.Use TFTP version 3 or above because these versions support a cryptographic authentication mechanism between peers.
最新試題
Which three techniques should be used to secure management protocols?()
Which statement is true when ICMP echo and echo-reply are disabled on edge devices?()
Refer to the exhibit. Which order correctly identifies the steps to provision a cable modem to connect to a headend as defined by the DOCSIS standard?()
If an edge Label Switch Router (LSR) is properly configured,which three combinations are possible?()
Which two statements about an IDS are true?()
Which three MPLS statements are true?()
Which two statements are true about broadband cable (HFC) systems?()
Which three statements about the Cisco Easy VPN feature are true?()
Which statement describes the Authentication Proxy feature?()
Which two statements about the Cisco AutoSecure feature are true?()