A. RARP
B. RUDP
C. ICMP
D. SNMP
您可能感興趣的試卷
你可能感興趣的試題
A. standardization
B. conversion
C. encapsulation
D. synchronization
A. path cisco.com
B. debug cisco.com
C. trace cisco.com
D. traceroute cisco.com
A. Serial0/1 is up, line protocol is down
B. Serial0/1 is down, line protocol is down
C. Serial0/1 is up, line protocol is up
D. Serial0/1 is administratively down, line protocol is down
A. Addresses are not hierarchical and are assigned at random.
B. Only one IPv6 address can exist on a given interface.
C. There are 2.7 billion addresses available.
D. Broadcasts have been eliminated and replaced with multicasts.
A. RIPng allows for routes with up to 30 hops.
B. RIPng is enabled on each interface separately.
C. RIPng uses broadcasts to exchange routes.
D. There can be only one RIPng process per router.
最新試題
An administrator must assign static IP addresses to the servers in a network.For network 192.168.20.24/29, the router is assigned the first usable host address while the sales server is given the last usable host address. Which of the following should be entered into the IP propertied box for the sales server?()
What is the purpose of the cisco Vlan Trunking protocol?()
Which command is used to display the collection of OSPF link states?()
Which statement describes the rule of split horizon?()
Which IPsec security protocol should be used when confidentiality is required?()
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?()
At which layer of the OSI model is RSTP used to prevent loops?()
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?()
A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?()
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0