單項選擇題Which command can be used from a PC to verfy the connectivity between host that connect through path?()

A. tracert address
B. ping address
C. arp address
D. traceroute address


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題What is the function of the command switchport trunk native vlan 999 on a switch?()

A. It designates VLAN 999 for untagged traffic.
B. It blocks VLAN 999 traffic from passing on the trunk.
C. It creates a VLAN 999 interface.
D. It designates VLAN 999 as the default for all unkown tagged traffic.

3.單項選擇題Which command can you use to manually assign a static IPV6 address to a router interface?()

A. ipv6 address PREFIX_1::1/64
B. ipv6 autoconfig 2001:db8:2222:7272::72/64
C. ipv6 autoconfig
D. ipv6 address 2001:db8:2222:7272::72/64

4.單項選擇題Why will a switch never learn a broadcast address?()

A. Broadcast frames are never sent to swiches.
B. Broadcast addresses use an incorrect format for the switching table.
C. A broadcast address will never be the source address of a frame.
D. Broadcasts only use network layer addressing.
E. A broadcast frame is never forwarded by a switch.

5.單項選擇題Which parameter can be tuned to affect the selection of a static route as a backup.when a dynamic protocol is also being used?()

A. link bandwidth
B. hop count
C. link cost
D. administrative distance
E. link delay

最新試題

Three switches are connected to one anther via trunk ports.Assuming the default switch configuration,which switch is elected as the root bridge for the spanning-tree instance of vlan 1?()

題型:?jiǎn)雾?xiàng)選擇題

Three access ports have been installed and configured to a small office.What term defines the wireless topology?()

題型:?jiǎn)雾?xiàng)選擇題

A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0

題型:?jiǎn)雾?xiàng)選擇題

What is the subnetwork address for a host with the IP address 201.100.5.68/28?()

題型:?jiǎn)雾?xiàng)選擇題

When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?()

題型:?jiǎn)雾?xiàng)選擇題

The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()

題型:?jiǎn)雾?xiàng)選擇題

Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?()

題型:?jiǎn)雾?xiàng)選擇題

An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?()

題型:?jiǎn)雾?xiàng)選擇題

What is the default administrative distance of OSPF?()

題型:?jiǎn)雾?xiàng)選擇題

A network administrator is planning a network installation for a large organization.The design requires 100 separate subnetworks,so the company has acquired a Class B network address.What subnet mask will provide the 100 subnetworks required, if 500 usable host addresses are required per subnet?()

題型:?jiǎn)雾?xiàng)選擇題