A. 2 through 1001
B. 1 through 1001
C. 1 through 1002
D. 2 through 1005
您可能感興趣的試卷
你可能感興趣的試題
A. (config-if)#authentication ppp chap fallback ppp
B. (config-if)#authentication ppp chap pap
C. (config-if)#ppp authentication chap pap
D. (config-if)#ppp authentication chap fallback ppp
A. Bandwidth,Delay,and MTU
B. Bandwidth
C. Bandwidth and MTU
D. Bandwidth , MTU,Reliability,Delay,and Load
A. reflexive
B. extended
C. standard
D. dynamic
A. redundant
B. spanned
C. provisioned
D. converged
A. NCP
B. LCP
C. ISDN
D. DLCI
E. SLIP
最新試題
A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?()
When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?()
Which pairing reflects a correct protocol-and-metric relationship?()
Which command encrypts all plaintext passwords?()
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()
After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?()
At which layer of the OSI model dose PPP perform?()
On which options are standard access list based?()
Which device might be installed at a branch office to enable and manage an IPsec site-to-site VPN?()
A network administrator is planning a network installation for a large organization.The design requires 100 separate subnetworks,so the company has acquired a Class B network address.What subnet mask will provide the 100 subnetworks required, if 500 usable host addresses are required per subnet?()