Refer to the exhibit. What is the maximum available bandwidth for the path between the workstation and the server?()
A.256 kb/S
B.512 kb/s
C.1 Mb/s
D.10 Mb/S
E.100 Mb/S
F.110.768 Mb/S
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. Which statement is true about the function of the frame-relay voice-bandwidth 24000 command that is shown in the partial configuration?()
A.It limits the total bandwidth available on the Frame Relay link.
B.It provides call admission control by limiting the number of voice calls over the Frame Relay link
C.It sets up IP RTP Priority features that reserve bandwidth for voice traffic flows.
D.It is functionally equivalent to configuring LLO.
E.It limits the bandwidth that is taken by individual voice calls to 24000 b/s.
A.Cisco Express Forwarding (CEF) must be globally enabled.
B.Prior to the enabling of the Cisco AutoOoS feature, the bandwidth command must be applied on all interfaces or subinterfaces.
C.After the enabling of the Cisco AutoOoS feature, the bandwidth command must be applied on all interfaces or subinterfaces .
D.OoS policies must be enabled on all interfaces that will participate in the AutoOoS configuration.
E.An IP address must be configured on all low-bandwidth interfaces (768 kb/s or lower) that will participate in the AutoOoS configuration
F.An IP address must be configured on all interfaces that will participate in the AutoOoS configuration
A.codec
B.link speed
C.Layer 2 encapsulation
D.packet overhead (IP/UDP/RTP)
E.link delay
F.total number of simultaneous calls that are allowed
A.The gateway voice-capable device is configured to support call control directly performing call setup, call maintenance, and call teardown
B.The gateway voice-capable device has a local call routing table configured through a routing protocol.
C.The gateway voice-capable device relies on a call agent to support call control.
D.The gateway voice-capable device relies on a gatekeeper to support call setup, call maintenance, and call teardown.
A.CoS 0 = Best-Effort Data
B.CoS 1 = Best-Effort Data
C.CoS 3 = High Priority
D.CoS 4 = High Priority Data
E.CoS 5 = Voice Bearer
F.CoS 7 = Voice Bearer
最新試題
SDM creates a low latency queuing (LLQ) service policy with its associated classes. What are the two types of low latency queuing available using the SDM QoS wizard?()
In the design of a QoS solution, which two factors should be taken into consideration?()
Which set of classes correctly identifies the four traffic classes, from highest priority to lowest priority, specified in the 802.11e standard?()
What are three factors used to determine the amount of bandwidth that is required for a single VoIP call? ()
When deploying a Cisco Wireless Control System (WCS) with the 2700 series location appliance, to within what range is on-demand location of rogue APs possible?()
Which two statements about the Wi-Fi Multimedia (WMM) standard are true?()
For delay sensitive traffic, what are the three best ways that are used to prevent packet loss? ()
What are three Cisco Unified CallManager features? ()
In a VoIP network, which type of interface would an analog fax machine connect to?()
What can be used to maintain the voice quality on a link by limiting the number of calls that can be active at any given time?()