A.passively listens to network traffic
B.is an active device in the traffic path
C.has a permissive interface that is used to monitor networks
D.traffic arrives on one IDS interface and exits on another
E.has a promiscuous interface that is used to monitor the network
您可能感興趣的試卷
你可能感興趣的試題
A. Employ path MTU discovery.
B. Set the MTU higher than 1500 bytes.
C. Turn off pre-fragmentation for IPSec.
D. Set the MTU value to 1400 bytes.
A.queuing
B.jitter
C.packet loss
D.digitized sampling
E.signal-to-noise ratio ratio
Refer to the exhibit. Which two of these are correct regarding the recommended practice for distribution layer design？（）
A.use a redundant link to the core
B.use a Layer 2 link between distribution switches
C.never use a redundant link to the core because of convergence issues
D.use a Layer 3 link between distribution switches with route summarization
E.use a Layer 3 link between distribution switches without route summarization
A. They do not receive unique IP addresses.
B. RADIUS or LDAP is required.
C. They are assigned addresses from the internal DHCP pool.
D. Their traffic appears to originate from the originating host network.
A.Delay should be no more than 10 ms.
B.Loss should be no more than1 percent.
C.Jitter should be less then 40 ms.
D.Managed bandwidth is strongly recommended for voice control traffic.
最新試題
What is the recommended practice when considering VPN termination and firewall placement?（）
How many channels are defined in the IEEE 802.11b DSSS channel set?（）
Which of the following is the primary consideration to scale VPNs?（）
One of your customers wishes to use the NAS to perform DHCP functions and does not currently have a Layer 3 gateway in its production network. Which gateway mode is appropriate for this customer?（）
Which signal and noise values will result in the best phone communication with an access point?（）
You are the Cisco Network Designer . Which is not major scaling, sizing, and performance consideration for an IPsec design?（）
What is the term for a logical SAN which provides isolation among devices physically connected to the same fabric?（）
Which of these is true of a Layer 3 out-of-band NAS deployment?（）
During consultation, you find that a customer has only a single asset closet and is looking for a solution that is easy to deploy. Which NAS physical deployment model would you suggest to this customer?（）
You are the Cisco Network Designer. Which of these is least important when determining how many users a NAS can support?（）