A.The IBGP routers must always be fully meshed.
B.The IBGP routers can be in a different AS.
C.The IBGP routers must be directly connected.
D.TThe IBGP routers do not need to be directly connected.
E.None of the other alternatives apply are true
您可能感興趣的試卷
你可能感興趣的試題
A network administrator is troubleshooting an EIGRP connection between RouterA， IP address10.1.2.1， and RouterB， IP address 10.1.2.2. Given the debug output on RouterA， which twostatements are true？（）
A.RouterA received a hello packet with mismatched metric-calculation mechanisms
B.RouterA received a hello packet with mismatched authentication parameters
C.RouterA will form an adjacency with RouterB
D.RouterA received a hello packet with mismatched autonomous system numbers
E.RouterA received a hello packet with mismatched hello timers
F.RouterA will not form an adjacency with RouterB
The following command was issued on Router 2：
Given the above output shown above， which statement is true？（）
A.192.168.1.0 is a redistributed route into EIGRP
B.192.168.1.0 is a summarized route
C.192.168.1.0 is a static route
D.192.168.1.0 is equal path load balancing with 172.16.1.0
E.None of the other alternatives apply
The EIGRP network is displayed in the following topology diagram：
You work as a network technician. Study the exhibits carefully. If the command "variance 3" wasadded to the EIGRP configuration of R5， which path or paths would be chosen to route traffic fromR5 to network X？（）
A.R5-R2-R1
B.R5-R2-R1 and R5-R3-R1
C.R5-R3-R1 and R5-R4-R1
D.R5-R2-R1，R5-R3-R1， and R5-R4-R1
A.Use the service-policy command to adjust the QOS policy to allow the route to propagate.
B.Clear the BGP session.
C.Use the release BGP routing command.
D.Change both the inbound and outbound policy related to this route.
E.None of the other alternatives apply
The network is shown below， along with the relevant router configurations：
With the topology found in the graphic， what will the R1 loopback 0 be in the R3 routing table？（）
A.It will show up in the routing table as D 10.0.0/8
B.It will show up in the routing table as D EX 10.0.0.0/8
C.It will show up in the routing table as D 10.0.0./24
D.It will not show up in R3 routing table because there is no network command on R1
最新試題
Drag and drop the steps in the process for provisioning a cable modem to connect to a headendon the above to the below in the order defined by the DOCSIS standard.
Drag and drop each function on the above to the hybrid fiber-coaxial architecture component that itdescribes on the below.
Drag the IPsec protocol description from the above to the correct protocol type on the below.（Notall descriptions will be used）Drag and Drop question， drag each item to its proper location.
Drag the DSL technologies on the left to their maximum（down/up） data rate values on the below.
Which statement about PPPoA configuration is correct？（）
Drag the DSL local loop topic on the left to the correct descriptions on the right.
Drag the protocols that are used to distribute MPLS labels from the above to the target area on thebelow.（Not all options will be used）
Which statement correctly describes IPsec VPN backup technology？（）
Router NetworkTut is configured as shown below：Given the above configuration， which statement is true？（）
Identify the recommended steps for worm attack mitigation by dragging and dropping them into thetarget area in the correct order.