A.The interface must be configured as a Multilink PPP interface.
B.The correct bandwidth should be configured on the interface.
C.A QoS policy must not be currently attached to the interface.
D.CEF must be enable
E.AutoQoS must be enabled globally before it can be enabled on the interface.
F.An IP address must be configured on the interface if its speed is equal to or less than 768 kbps.
您可能感興趣的試卷
你可能感興趣的試題
A.show ip bgp
B.show ip bgp paths
C.show ip bgp peers
D.show ip bgp summary
E.show ip bgp protocols
A problem was reported that the 10.10.10.0/24 prefix was not injected into the local BGP table ona Company router named R1. The following information is available from this router：
R1 Configuration：
router bgp 65001
network 10.0.0.0
neighbor 172.16.1.1 remote-as 65002
no auto-summary
Routing table information：
show ip route | include 10
O 10.10.10.0/24 [110/11] via 192.168.1.1， 2d00h， Ethernet0/0
Why is this prefix not in the local BGP table of the R1？（）
A.The 172.16.1.1 neighbor is down.
B.The prefix 10.10.10.0/24 is not a ’connected’ route
C.This route is not a BGP learned route
D.The network command is wrong
E.None of the other alternatives apply
A.show ospf
B.show ip route
C.show ip protocols
D.show ip ospf database
E.None of the other alternatives apply
Exhibit：
You work as a network technician. You trainee shows you the IOS command output displayed inthe exhibit. What command did Tess use to produce this output？（）
A.show ip RIP
B.show ipv6 ospf
C.show ip ospf
D.show ip ospf interface
E.show ipv6 ospf interface
F.show ipv4 ospf
G.None of the other alternatives apply
A.Serial connection
B.Secure Shell
C.RADIUS
D.Simple Network Management Protocol
E.HTTP
F.Telnet
最新試題
Identify the recommended steps for worm attack mitigation by dragging and dropping them into thetarget area in the correct order.
Drag and drop question. The upper gives the MPLS functions， the bottom describes the planes.Drag the above items to the proper location at the below
Network Topology Exhibit：Configuration Exhibit：NET（config）# access-list 112 deny icmp any any echo logNET（config）# access-list 112 deny imp any any redirect logNET（config）# access-list 112 deny icmp any any mask-request logNET（config）# access-list 112 permit icmp any 10.1.1.0 0.0.0.255NET（config）# interface Fa0/1NET（config-if）# ip access-group 112 inYou work as a network administrator at networkTut.com， study the exhibit carefully. Theconfiguration has been applied to router NET to mitigate the threat of certain types of ICMPbasedattacks while allowing some ICMP traffic to the corporate LAN to work. However， the configurationis incorrect. On the basis of the information in the exhibit， which configuration option wouldcorrectly configure router NET？（）
Drag and drop the steps in the process for provisioning a cable modem to connect to a headendon the above to the below in the order defined by the DOCSIS standard.
Drag the IPsec protocol description from the above to the correct protocol type on the below.（Notall descriptions will be used）Drag and Drop question， drag each item to its proper location.
Which two encapsulation methods require that an 827 ADSL router be configured with a PPPusername and CHAP password？（）
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec， which two parameters are required when defining the tunnel interfaceinformation？（）
IPSec VPN is a widely-acknowledged solution for enterprise network. What are the four steps tosetup an IPsec VPN？（）
Drag the IOS commands from the left that would be used to implement a GRE tunnel using the10.1.1.0.30 network on interface serial 0/0 to the correct target area on the right.
As a network technician， do you know what is a recommended practice for secure configurationmanagement？（）