A.Clear the BGP session
B.Change both the inbound and outbound policy related to this route
C.Use the service-policy command to adjust the QOS policy to allow the route to propagate
D.Use the release BGP routing command
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. Router RTR is attempting to establish BGP neighbor relationships with routersRT1 and RT3. On the basis of the information that is presented in the exhibit, which twostatements are true?()
A.RTR has a BGP password set but neighbor 10.0.0.1 does not
B.Neighbor 10.0.0.5 has a BGP password set but RTR does not
C.RTR has a BGP password set but neighbor 10.0.0.5 does not
D.RTR has a BGP password set but neighbor 10.0.0.1 has an incorrect password set
E.Neighbor 10.0.0.1 has a BGP password set but RTR does not.
F.RTR has a BGP password set but neighbor 10.0.0.5 has an incorrect password set
A.it is not a valid NetFlow command.
B.it is an SNMP command tha texports1500-byte packets to IPaddress192.168.1.50.
C.it is a NetFlov/command that v/ill export 1500-byte packets to IP address192.168.1.50.
D.it is a NetFlov/command that allows IP address192.168.1.50 to send traffic to port 1500.
E.It is a NetFlov/command that v/ill specify that the NetFlov/collector’s IP address is 192.168.1.50 over UDP port 1500
While verifying BGP operation on the Company router, you issue the "show ip bgp" command asshown below:
From the information above, which path will the network 143.16.0.0 prefer to take to exit the AS?()
A.128.214.63.2
B.192.208.10.5
C.128.213.63.5
D.203.250.13.41
E.All of the above will be used in a round robin fashion
This item contains several questions that you must answer. You can view these questions byclicking on the Questions button to the left. Changing questions can be accomplished by clickingthe numbers to the left of each question. In order to complete the questions, you will need to referto the SDM and the topology, neither of which is currently visible. To gain access to either thetopology or the SDM, click on the button to left side of the screen that corresponds to the sectionyou wish to access. When you have finished viewing the topology the SDM, you can return to yourquestions by clicking on the Questions button to the left.
Off Shore Industries is a large worldwide sailing charter. The company has recently upgraded itsInternet connectivity. As a recent addition to the network engineering team, you have been taskedwith documenting the active Firewall configurations on the Annapolis router using the Cisco Routerand Security Device Manager (SDM) utility. Using the SDM output from Firewall and ACL Tasksunder the Configure tab, answer the following questions:
Which two options would be correct for a permissible incoming TCP packet on an untrustedinterface in this configuration?()
A.The packet has a source address of 172.16.29.12
B.The packet has a source address of 10.94.61.29
C.The session originated from a trusted interface
D.The application is not specified within the inspection rule SDM_LOW
E.The packet has a source address of 198.133.219.144
A.Following the traffic path
B.Top-down
C.Comparing configurations
D.Bottom-up
E.Divide and conquer
F.ExamineS LAs
最新試題
cisco ios command to interface dialer 0
Drag the DSL local loop topic on the left to the correct descriptions on the right.
As a network engineer, do you know for what purpose SDM uses Security Device Event Exchange(SDEE)?()
Study this exhibit carefully. What information can be derived from the SDM firewall configurationdisplayed?()
As a network technician, do you know what is a recommended practice for secure configurationmanagement?()
Which statement correctly describes IPsec VPN backup technology?()
Drag and drop the steps in the process for provisioning a cable modem to connect to a headendon the above to the below in the order defined by the DOCSIS standard.
Drag the protocols that are used to distribute MPLS labels from the above to the target area on thebelow.(Not all options will be used)
A new router was configured with the following commands:The configuration above was found on an Internet Service Provider’s (ISP) Multiprotocol LabelSwitching (MPLS) network. What is its purpose?()
Drag the IPsec protocol description from the above to the correct protocol type on the below.(Notall descriptions will be used)Drag and Drop question, drag each item to its proper location.