RIP and OSPF are configured on the routers as shown in the exhibit. R2 is configured with a two-way redistribution between RIP and OSPF domains. All routers can ping each other， but R1cannot see any of the OSPF routes in its routing table. What could the problem be？（）
A.OSPF and RIP use the same major network 172.16.0.0. Therefore， the keywordsubnets is notrequired to redistribute protocols into OSPF
B.Because OSPF has a longer mask for the same major network than RIP and because RIPversion 1 is being used， none of the routes learned from OSPF will be advertised into RIP
C.The metric for the OSPF routes that are redistributed into RIP is too low， a fact that preventsOSPF routes from being advertised into RIP
D.The process of redistribution of RIP into OSPF does not require any metric conversion， so thereis no need to define the metric using the default-metric command during the redistribution
您可能感興趣的試卷
你可能感興趣的試題
Refer to the network shown below：
R1 and R2 belong to the RIP routing domain that includes the networks 10.20.0.0/16 and
10.21.0.0/16. R3 and R4 are performing two-way route redistribution between OSPF and RIP. Anetwork administrator has discovered that R2 is receiving OSPF routes for the networks
10.20.0.0/16 and 10.21.0.0/16 and a routing loop has occurred. Which action will correct thisproblem？（）
A.Set the OSPF default metric to 20
B.Apply an inbound ACL to the R2 serial interface
C.Configure distribute-lists on R3 and R4
D.Change the RIP administrative distance on R3 to 110
E.Change the OSPF administrative distance on R3 to 110
F.None of the other alternatives apply
Refer to the exhibit. The routing protocols EIGRP and OSPF have been configured as indicated inthe exhibit. Given the partial configuration of router R2， which network will be present in the routingtable of R4？（）
A.Network B
B.Network A and Network B
C.Network A
D.neither Network A nor Network B
Refer to the exhibit and the partial configuration on router R2. On router R4 all RIP routes areredistributed into the OSPF domain. A second redistribution is configured on router R2 using aroute map. Based on the configuration on router R2， which EIGRP external routes will be presentin the routing table of R1？（）
A.There will be no EIGRP external routes in the routing table of R1
B.The routes originating from the RIP routing domain
C.Only routes originating in the OSPF routing domain
D.All routes originating from RIP and OSPF routing domains
E.None of the other alternatives apply
A.00-00-0c-c0-05-0a
B.00-00-0c-cl-05-0a
C.01-00-5e-00-00-0c
D.01-00-5e-41-05-0a
E.00-00-0c-01-00-5e
F.01-00-5e-cl-05-0a
A.Incorrect distribute lists have been configured
B.Missing ip classless command
C.CEF not enabled
D.No default metric configured for EIGRP
最新試題
Which statement correctly describes IPsec VPN backup technology？（）
As a network engineer， do you know for what purpose SDM uses Security Device Event Exchange（SDEE）？（）
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec， which two parameters are required when defining the tunnel interfaceinformation？（）
Match the xDSL type on the above to the most appropriate implementation on the below.
Drag the DSL technologies on the left to their maximum（down/up） data rate values on the below.
Drag each element of the Cisco IOS Firewall Feature Set from the above and drop onto itsdescription on the below.
Drag and drop the xDSL type on the above to the appropriate xDSL description on the below.
Which statement about PPPoA configuration is correct？（）
A new router was configured with the following commands：The configuration above was found on an Internet Service Provider’s （ISP） Multiprotocol LabelSwitching （MPLS） network. What is its purpose？（）
Refer to the exhibit. Which two statements about the AAA configuration are true？（）