Two Company switches are connected via a trunk link. In this network, the original frame is encapsulated and an additional header is added before the frame is carried over a trunk link. At the receiving end, the header is removed and the frame is forwarded to the assigned VLAN.
This describes which technology?()
A. DISL
B. ISL
C. DTP
D. IEEE 802.1Q
E. MPLS
F. None of the other alternatives apply
您可能感興趣的試卷
你可能感興趣的試題
When the Catalyst switch R1 is enabled to use VTP,
which information does it advertise on its trunk ports?()
A. VTP mode
B. STP root status
C. Negotiation status
D. Management domain
E. Configuration revision number
Switch R1 is configured with VTP.
Which two VTP modes will make R1 capable of creating and deleting VLANs on itself? ()
A. Client
B. Server
C. Transparent
D. Pass-through
E. No-negotiate
What action should you execute if you wanted to enable VTP pruning on your entire management domain?()
A. Enable VTP pruning on any client switch in the management domain.
B. Enable VTP pruning on any switch in the management domain.
C. Enable VTP pruning on every switch in the management domain.
D. Enable VTP pruning on a VTP server in the management domain.
E. Disable VTP pruning on a VTP server in the management domain.
A.It does not prune traffic from VLANs that are pruning-ineligible
B.VLAN 1 is always pruning-eligible
C.It will prune traffic from VLANs that are pruning-ineligible
D.VLAN 2 is always pruning-ineligible
E.None of the other alternatives apply
A.Domain advertisements
B.Advertisement requests from clients
C.Subset advertisements
D.Summary advertisements
最新試題
Refer to the exhibit. On the basis of the output of the show spanning-tree inconsistentports command, which statement about interfaces FastEthernet 0/1 and FastEthernet 0/2 is true?()
DS2 has not become the active device for Vlan103’s HSRP group even though all interfaces are active. As related to Vlan103’s HSRP group. What can be done to make the group function properly ? ()
During routine maintenance, G1/0/1 on DS1 was shutdown. All other interface were up. DS2 became the active HSRP device for Vlan101 as desired. However, after G1/0/1 on DS1 was reactivated. DS1 did not become the active HSRP device as desired. What need to be done to make the group for Vlan101 function properly ? ()
Refer to the exhibit. For what purpose is the command show ip cef used?()
Refer to the exhibit. Based on the output of the show spanning-tree command, which statement is true? ()
What will occur when a nonedge switch port that is configured for Rapid Spanning Tree does not receive a BPDU from its neighbor for three consecutive hello time intervals?()
Which three statements are true of the Link Aggregation Control Protocol (LACP)?()
Which two statements about the various implementations of STP are true?()
Examine the diagram. A network administrator has recently installed the above switched network using 3550s and would like to control the selection of the root bridge.Which switch should theadministrator configure as the root bridge and which configuration command must theadministrator enter to accomplish this?()
Refer to the exhibit. What command was issued on the Layer 3 switch Sw1 between Exhibit #1 and Exhibit #2?()