Refer to the exhibit.
Which two Lightweight Access Point statements are true？（）
A. An AP that has been upgraded from an autonomous AP to lightweight AP will only function in conjunction with a Cisco Wireless LAN controller.
B. LWAPP increases the amount of processing within the APs， enabling them to support filtering and policy enforcement features.
C. WLAN controllers provide a single point of management.
D. Lightweight APs require local configurations using local management.
E. Real time events such as authentication， security management， and mobility are handled by the lightweight AP.
F. Autonomous APs receive control and configuration information from a WLAN controller.
您可能感興趣的試卷
你可能感興趣的試題
On the Company wireless LAN， A client is searching for an access point （AP）.
What is the correct process order that this Company client and access point goes through in order to create a connection？（）
A. association request/response， probe request/response， authentication request/response
B. association request/response， authentication request/response， probe request/response
C. probe request/response， authentication request/response， association request/response
D. probe request/response， association request/response， authentication request/response
E. None of the other alternatives apply
Refer to the exhibit. The signal transmitted from the AP is reflected off a wall resulting in multipath interference at the client end.
Which statement is true？ （）
A. The transmitted signal from the AP arrives at the client at slightly different times resulting in phase shifting.
B. If signal 2 is close to 360 degrees out of phase with signal 1， the result is essentially zerosignal or a dead spot in the WLAN.
C. Multipath interference is less of an issue when using a DSSS technology because multipath is frequency selective.
D. If signal 1 is in phase with signal 2， the result is essentially zerosignal or a dead spot in the WLAN.
E. Multipath interference is solved by using dual antennas.
You work as a network technician at Company. Please study the exhibit carefully. In this
Company wireless network， the LAP （lightweight access point） attempts to register to a WLC （Wireless LAN Controller）.
What kind of message is transmitted？（）
A. The lightweight access point will send Layer 2 and Layer 3 Lightweight Access Point （LWAPP） mode discovery request messages at the same time.
B. The lightweight access point will send Layer 3 Lightweight Access Point （LWAPP） mode discovery request messages only.
C. The lightweight access point will send Layer 2 Lightweight Access Point （LWAPP） mode
D.iscovery request messages. If the attempt fails， the LAP will try Layer 3 LWAPP WLC discovery. D. The lightweight access point will send Layer 2 Lightweight Access Point （LWAPP） mode discovery request messages only.
LDAP is being used throughout the Company wireless network.
Which statement about the Lightweight Access Point Protocol （LWAPP） protocol is true？（）
A. The processing of 802.11 data and management protocols and access point capabilities is distributed between a lightweight access point and a centralized WLAN controller.
B. LWAPP advertises its WDS capability and participates in electing the best WDS device for the wireless LAN.
C. LWAPP aggregates radio management forward information and sends it to a wireless LAN solution engine.
D. LWAPP authenticates all access points in the subnet and establishes a secure communication channel with each of them.
E. None of the other alternatives apply
Refer to the exhibit. Both host stations are part of the same subnet but are in different VLANs. On the basis of the information presented in the exhibit，
which statement is true about an attempt to ping from host to host？ （）
A. The two different hosts will need to be in the same VLAN in order for the ping command to be successful.
B. A Layer 3 device is needed for the ping command to be successful.
C. The ping command will be successful without any further configuration changes.
D. A trunk port will need to be configured on the link between Sw_A and Sw_B for the ping command to be successful.
最新試題
Refer to the exhibit and the partial configuration of switch SW_A and SW_B. STP is configured on all switches in the network. SW_B receives this error message on the console port：00：06：34： %CDP-4-DUPLEX_MISMATCH： duplex mismatch discovered on FastEthernet0/5 （not half duplex）， with SW_A FastEthernet0/4 （half duplex） ， with TBA05071417（Cat6K-B） 0/4 （half duplex）. What would be the possible outcome of the problem？（）
Which two statements are true about BPDU port-guard and BPDU filtering？（）
Based on the show spanning-tree vlan 200 output shown in the exhibit， which two statements about the STP process for VLAN 200 are true？ （）
Refer to the exhibit. What will happen when one more user is connected to interface FastEthernet 5/1？ （）
What two things will occur when an edge port receives a BPDU？（）
What is the configured priority value of the Vlan105’s group on DS2 ？（）
Which option correctly identifies the Cisco IOS switching methods in descending order from the fastest method to the slowest method？（）
Which three statements about STP timers are true？（）
How are STP timers and state transitions affected when a topology change occurs in an STP environment？（）
Refer to the exhibit. Which statement is true about the output？（）