A. A successor route is used by EIGRP to forward traffic to destination.
B. Successor routes are saved in the topology table to be used if the primary route fails.
C. Successor routes are flagged as "active" in the routing table.
D. A successor route may be backed up by a feasible successor route.
E. Successor routes are stored in the neighbor table following the discovery process.
您可能感興趣的試卷
你可能感興趣的試題
A. In the routing table only.
B. In the neighbor table only.
C. In the topology table only.
D. In the routing table and neighbor table.
E. In the routing table and topology table.
F. In the topology table and neighbor table.
A. point-to-point
B. Backbone area 0
C. Broadcast multicast
D. Non-broadcast multi-access
E. The DR/BDR process is done for all interface types
A. The update information will be added to the existing routing table.
B. The update information will replace the existing routing table entry.
C. The update will be ignored and thus no further action will occur.
D. The existing routing table entry will be purged from the routing table and all routers will attempt convergence.
A.90
B.100
C.110
D.120
E.130
F.170
G.200
A RIP router has an entry in the routing table for a specific network destination. It then gets updated with another entry for that same destination, but with a higher path cost (hop count) than the one already in the routing table.
What will the router do in this situation?（）
A. It will ignore the update and take no further action.
B. It will add the update information to its routing table.
C. It will replace the existing routing table entry with the update information.
D. It will delete the existing routing table and will send out hello packets to rebuild the routing table.
最新試題
Which characteristics are representative of a link-state routing protocol?（）
Which of the following contribute to congestion on an Ethernet network?（）
An administrator would like to configure a switch over a virtual terminal connection from locations outside of the local LAN. Which of the following are required in order for the switch to be configured from a remote location? （）
Which command is required for connectivity in a Frame Relay network if Inverse ARP is not operational? （）
You are configuring a new Catalyst switch that you want to manage remotely from workstations on other network segments within your enterprise.Which of the following are required to allow remote management of the switch over IP?（）
Five minutes after issuing the show running-config command, a technician enters the command again and notices that several access list statements have been altered. Because of this, the technician believes that the router is being configured by an unknown person through Telnet. Before changing the router passwords, the technician would like to discover if anyone is connected to the router by Telnet and stop them from making further changes.Which commands will accomplish these options?（）
What should the configuration register value be after successfully completing the password recover procedure and returning the router to normal operation? （）
Which of the following correctly describe steps in the OSI data encapsulation process?（）
Identify three valid host addresses in the 192.168.27.0 network with a subnet mask of 255.255.255.240. （）
Which of the following if addresses can be assigned to host devices?（）