Refer to the exhibit. Users complain that they intermittently lose data and connections toimportant servers. After investigation, you discover that the 802.1Q trunk between DSW111 andASW1 is down. Even though the HSRP group 11 is being serviced by DSW112, you discover thatthe SVI for VLAN 11 is in the up state on DSW111. Which three Cisco Catalyst IOS commands
should you use on DSW111 to find the source of this problem? （）(Choose three.)
A. show vtp status
B. show interfaces vlan 11
C. show standby vlan 11 brief
D. show spanning-tree vlan 11
E. show interfaces
您可能感興趣的試卷
你可能感興趣的試題
A. This approach separates technologies based on customer buying patterns.
B. This approach integrates solutions by combining technologies that are aligned to customer buying patterns.
C. Although this approach supports verticalization, it is not aligned to partner programs.
D. Although this approach is aligned to partner programs, it does not support verticalization.
最新試題
As a network administrator, you issue the interface auto qos voip cisco-phone command on a port in an edge network. It is possible for a Cisco Catalyst switch to check if a Cisco IP Phone is directly attached to that port by:（）
In a high-availability network, which command, when placed on ports that have connected end stations, will allow you to prevent delays in service for end stations by placing a port in blocking mode?（）
What is the maximum number of Cisco Catalyst 3750 Series Switches that can be united into a single manageable unit using the Cisco StackWise technology?（）
Which Cisco IOS command is used to troubleshoot a problem in which a BGP session stays in the active state?（）
Referring to the partial Cisco Catalyst switch configuration shown, which two of these statements are correct? （）(Choose two.)
As an experienced network engineer, you are asked to troubleshoot a CIS network outage. During the troubleshooting process, you notice that one of your colleagues connects additional devices to the network with the use of his own switch. With the purpose of improving speed, the switch is attached to both network ports in an office, which leads to bridge loop.Enabling which of the following feature will be able to prevent this problem from happening again?（）
What is the function of the no switchport catalyst switch interface configuration command?（）
Which keyword is used with the debug ipv6 [keyword] command to troubleshoot neighbor discovery problems?（）
Which command displays only those entries in a BGP table with specific AS_PATH attributes?（）
Refer to the exhibit. Analyze the two traceroutes that are displayed. Which of these statements is correct in describing what most likely caused the traceroute differences?（）