You are installing a cisco 4402 series wireless lan controller.
Which type of interface should you use on the controller’s distribution port？（）
A.1000base-sx sfp
B.10/100/1000 mbps rj45
C.10/100 mbps rj45
D.10000base-sx
您可能感興趣的試卷
你可能感興趣的試題
By default，on the wlan controller for a voice application using cisco 7921 wireless ip phones.
what is the percentage of rf bandwidth that can be dedicated to the phones？（）
A.75 percent
B.85 percent
C.56 percent
D.55 percent
A.clients connected to the rogue access point must be able to connect to the containment controller-based access point.
B.multiple controller-based access points will load-balance the containment task using fewer resources than a single access point.
C.clients connected to the rogue access point may be out of the range of the controller-based access point providing containment.
D.each controller-based access point can handle only a limited amount of clients connected to the rogue access points.
A.c1130-k9w7-tar.boot
B.c1130-k9w7-tar.123-7.ja1.tar
C.c1130-k9w7-tar.default
D.c1130-k9w7-tar.recover
A.problem management
B.configuration management
C.incident management
D.change management
A.technology assessment
B.operations assessment
C.security assessment
D.security administration
E.change management
最新試題
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones，which two general control settings should you select？（）
The Cisco Wireless Location Appliance provides an audit trail for each device tracked for up to how many days？（）
A mobility group is created by a Cisco WLCM and 4402 Series Wireless LAN Controller. A client thatis anchored on the Cisco WLCM roams to an access point on the 4402 controller. You then run adebug command on the 4402 controller.Which message would best describe the establishment ofthe tunnel from the foreign controller’s perspective？（）
You are trying to change the polling parameters used by the location manager via the Cisco WCS，and your request is being denied. What is wrong？（）
You review the Failed Attempts logs on an AAA server and find： "unknown network access servererror." Which failure could produce this error？（）
You have a very few Cisco 7920 wireless IP phones on your network， but lots of wireless laptops.You want to increase the bandwidth available for the laptops by decreasing the bandwidth reserved for the Cisco 7920 phones.What is the lowest percentage of voice-allocated bandwidthyou can select on the WLAN controller？（）
You are charges with implementing a secure wireless installation which will provide Internet accessto client devices but will not allow communications between wireless clients.In addition to implementing PSPF or peer-to-peer blocking on the wireless side，which of the following actionsshould you perform on the wired infrastructure？（）
A client roams from H-REAP AP1 to H-REAP AP2. The client is unable to associate to H-REAP AP2.H-REAP AP2 has six other clients associated to it， which continue to pass traffic.What has causedthis problem？（）
You have just finished aligning a Cisco Aironet 1400 Series Wireless Bridge link using installationmode. When you set the link back to operational mode you loose association to the root bridge.Which action will correct the problem？（）
Clients using Cisco-LEAP and EAP-FAST authentication are having no problems logging on to thewireless network， but clients using PEAP are failing to log on.Which situation would result in thistype of problem？（）