A.Identify potential problem areas
B.Define intended coverage areas
C.Access compliance with local building codes
D.Determine the final location of APs and antennas
E.Identify sources of RF signal attenuation and RF interference
您可能感興趣的試卷
你可能感興趣的試題
A.Implementation suggestions
B.Access point locations
C.Security requirements
D.Access point mounting methods
A.Access point received-signal strength level
B.Spectrum utilization
C.Client data rate
D.In-band radio frequency interference
A.300
B.448
C.664
D.1800
E.2400
最新試題
Which antenna generally has the narrowest first Fresnel zone in both the horizontal and verticalplanes?()
A design requires 100 access points with high channel bandwidth and disabled lower data rates.How are the data rates set on the Cisco WLC and Cisco WCS?()
What does a broad-spectrum interferer lower?()
The Cisco Aironet 1140 Series Access Point draws 12.95 W at the power source. However, whenusing a long Ethernet cable, the device can draw up to how much additional wattage?()
Which two Cisco antennas provide better isolation from RF sources that might be located behindthe antennas?()
What is a site survey best practice for location-based services?()
After the site installation is complete, you should verify the mobility of the VoWLAN device whilewalking the site on an active phone call. Which Cisco WLC or Cisco WCS command is mostbeneficial in determining roaming efficiency?()
Which format can NOT be imported into Cisco WCS Planning Tool?()
Which three formats can be used to import floor maps in Cisco WCS v5.2?()
In an outdoor bridge link, what is calculated by using this formula: transmitter power + antennagain - insertion OR cable loss()?